Integrated dehumidifying, drying and feeding in one unit. Feeding to 1 molding machine is standard configuration, feeding up to 3 molding machines is optional.
Controlled by microprocessor with P.I.D. temperature control.
Consists-condenser provides lower return air temperature and dew point below -40°C (-50°C is available with chilling water)
Chinese and English interface is available, easy to operate system and to understand warning messages.
Insulating drying hopper with European standard allows better heat preservation and being damped.
Fully sealed feeding system to prevent dried material contacting open air and being damped.
Discharge valve ensure no residual materials in hopper tubes each time.
Small footprint and moveable.
PLC control with enhanced configuration is optional for feeding up to 5 molding machines.
Dew-point monitor is optional.
Material contact parts are made of stainless steel.
Precise die cast aluminium housing with smooth surface and good heat preservation.
Adopted low noise blower, and the optional air filter ensures material purity.
Adopted dial thermometer for accurate temperature control.
Material tank is installed with glass for inspection
Curved heating cylinder is designed to avoid power jam and overheat.
Hopper is designed for easy opening, suitable for all robots.
